Investigation of the soot formation in ethylene laminar diffusion flames when diluted with helium or supplemented by hydrogen

A new optical diagnostic technique has been used to measure the spatially distributed temperatures, soot diameters, and soot volume fractions in several different ethylene laminar diffusion flames to investigate the effect of adding hydrogen and helium on the soot formation. The test results show that adding hydrogen increases the flame temperature in all regions, while adding helium does not significantly affect the flame temperature in the reaction region but does increase the flame temperature elsewhere. The flame heights when adding helium and hydrogen can be calculated using the correlation introduced by Roper if the ethylene diffusion coefficient is used. This indicates that the flame height is determined by the diffusion of ethylene molecules when the hydrogen fraction is below 20%. It was also found that either adding helium or hydrogen does not significantly affect the soot diameter but does reduce the soot volume fraction. A total of 20% of helium addition by volume was measured to reduce the total soot number by 19%, while a total of 20% of hydrogen addition reduced the total soot number by 23%. In comparison, replacing the hydrocarbon with hydrogen is much more effective in reducing soot formation. Replacement of 25% ethylene by hydrogen was measured to reduce the total soot number by 66%. Apart from demonstrating the influence of hydrogen and helium on ethylene diffusion flames, these measurements provide additional data for modelers of diffusion flames, especially those with an interest in the formation of particulate matter. © 2014 American Chemical Society

Measurement of the spatially distributed temperature and soot loadings in a laminar diffusion flame using a Cone-Beam Tomography technique

A new low-cost optical diagnostic technique, called Cone Beam Tomographic Three Colour Spectrometry (CBT-TCS), has been developed to measure the planar distributions of temperature, soot particle size, and soot volume fraction in a co-flow axi-symmetric laminar diffusion flame. The image of a flame is recorded by a colour camera, and then by using colour interpolation and applying a cone beam tomography algorithm, a colour map can be reconstructed that corresponds to a diametral plane. Look-up tables calculated using Planck's law and different scattering models are then employed to deduce the temperature, approximate average soot particle size and soot volume fraction in each voxel (volumetric pixel). A sensitivity analysis of the look-up tables shows that the results have a high temperature resolution but a relatively low soot particle size resolution. The assumptions underlying the technique are discussed in detail. Sample data from an ethylene laminar diffusion flame are compared with data in the literature for similar flames. The comparison shows very consistent temperature and soot volume fraction profiles. Further analysis indicates that the difference seen in comparison with published results are within the measurement uncertainties. This methodology is ready to be applied to measure 3D data by capturing multiple flame images from different angles for non-axisymmetric flame. © 2013 Elsevier Ltd

Insights into technical challenges in the field of microplastic pollution through the lens of early career researchers (ECRs) and a proposed pathway forward

Early career researchers (ECR) face a series of challenges related to the inherent difficulties of starting their careers. Microplastic (MP) research is a topical field attracting high numbers of ECRs with diverse backgrounds and expertise from a wealth of disciplines including environmental science, biology, chemistry and ecotoxicology. In this perspective the challenges that could hinder scientific, professional, or personal development are explored, as identified by an international network of ECRs, all employed in MP research, that was formed following a bilateral workshop for scientists based in the UK and China. Discussions amongst the network were grouped into four overarching themes of technical challenges: in the field, in the laboratory, in the post data collection phase, and miscellaneous. The three key areas of representativeness, access to appropriate resources, training, and clean labs, and the use of databases and comparability, as well as the overarching constraint of available time were identified as the source of the majority of challenges. A set of recommendations for pathways forward are proposed based on the principles of research openness, access to information and training, and widening collaborations. ECRs have great capacity to promote research excellence in the field of MPs and elsewhere, when provided with appropriate opportunities and suitable support.</p